Vanessa Ezekowitz

Tools

Generic crystal - Basic 4-pin crystal "XTAL" type oscillator
4-resistor network - Basic isolated four-in-one resistor network, counter-clockwise pin numbering.
4-resistor network - same thing, left-to-right numbering.
5-resistor network - Basic isolated five-in-one resistor network, counter-clockwise pin numbering.
5-resistor network - Same thing, left-to-right numbering.
8-resistor network - Basic isolated eight-in-one resistor network.
Ferrite Bead - Just a common ferrite bead (a generic box with two generic pins. :-) ).

TC7WU04F - Three invertors in one package (Toshiba).
TLC7226CN - Quad 8-bit Digital to Analog converter (Texas Instruments).
CY7C138 - 4k x 8 dual-port SRAM (Cypress).
DS1135 - triple 10ns delay line (Maxim).
74*4040 - 12-bit binary counter with reset.
LM324 - Generic quad Op-Amp.
STA013T - MP3 decoder IC, TQFP44 package (STMicroelectronics).
MAS3507D - Another MP3 decoder chip, PLCC44 only, obsolete (Micronas Intermetall).
CS4331 - dual 18-bit A/D converter, serial interface (Cirrus)
8726 REC - Standard REC chip used in Commodore 17xx REUs (Commodore/MOS).
41256 - Common 41256 256 kbit x 1 DRAM chip.
HM51440A - 1Mb x 4 DRAM chip, for ZIP-20 package (Hitachi).
VBT1-S5-S12-SMT - 5v to 12v DC-DC converter (83mA output), probably works for most of their other single-output modules as well, judging by their datasheet (V-Infinity).

C64/C128 User Port - Derived from Leon Kos' generic 24-pin connector.
Stereo Jack - Common two-channel "stereo" connector.
Female DIN-5 - Female 5-pin round DIN connector (common, for old AT keyboards, C64 video, etc.
PowerJack-2.sym - Common DC power jack.
PowerJack-3.sym - Common DC power jack - without dotted lines.

Basic non-polarized capacitor - 200-mil lead spacing, commonly for small ceramics, polyester film, etc.
Resistor/Diode - 100-mil lead spacing for folded-over 1/8W resistors and small diodes like 1N914. Also *just* fits 1/4W resistors. Not for 1N400x-type diodes (leads on these are usually too thick).
Common TO-18 - For 2N2222 or similar, derived from Eagle part.

Four-in-one resistor network - 0603 (x4) surface mount isolated resistor pack (Yageo YC164 series).
PTS625SL50-LFS - SPST momentary switch, normally open, low-profile pushbutton type (C&K Components).
Common Mounting hole - A simple screw hole, 350 mil pad diameter, 130 mill drill (as a component so PCB won't move it around).
PT10LH01 - Common potentiometer - standing upright, horizontal shaft (Piher)
DIP 12 - Simple 12-pin DIP package.
Fuseholder - Common 5mm diamater fuse holder; two separate clips joined into one footprint (Littelfuse).
2-pad jumper - Surface mount style jumper pads, 40 mil square.
3-pad jumper - Surface mount style jumper pads, 40 mil square.

Male 44-pin card edge - 100 mil pin spacing, Suitable to plug into Commodore 64/128 "Expansion Port" connector.
Male 44-pin card edge, no silk - (derived from the above, without the silk layer so it can be connected to from either edge)
Male 44-pin card edge, short - (derived from above, even shorter (useful as test points, or to mount something at the edge of a board).
Female 44-pin edge connector - 100 mil pin spacing, 200 mil row spacing, with silk added to mark "keepout" areas around it to match Commodore 64 "Expansion Port".

2-794954-0 - Female ATX Connector, as used on most mainboards. 20-pin version, from datasheet (Tyco/AMP).
2-1586041-0 - Female ATX, Right angle, 20 pin version, from datasheet (Tyco/AMP).
Female 5-pin DIN - PCB mounted, suitable for older keyboards, etc. derived from Eagle part.
Female 15-pin D-Sub - Standard female VGA connector, derived from Eagle part.
Female 15-pin D-Sub (short) - Shortened version suitable for use at the edge of a board, similar to PCB's other D-Sub connectors.
Female 44-pin edge connector - Typical, 100 mil pin spacing, 191 mil row spacing.
Male 24-pin card edge - 156 mil spacing, suitable to attach a Commodore 64 "User Port" connector to.
PG203J - Basic 3.5mm stereo jack (the kind Radio Shack sells), derived from Eagle part.
SJ13533NG - Lower-profile 3.5mm stereo jack, without internal switches, based on datasheet (CUI, Inc).
163-7620-E - 5.5mm outer contact, 2.1mm pin diameter (Kobiconn).
DC0202 - Female DC Power jack. Generic footprint, derived from Eagle part.

V-Infinity-VBT1.fp - 5v to 12v DC-DC converter, ~300 mil body width, 100 mil lead spacing (like DIP) but surface mounted (V-Infinity).